For a couple days I’ve been having an issue with every print I’ve done, when I push start everything goes fine. However, once it reaches its first layer temperature, it will go down to the temperature for other lays, it will also say x minutes remaining and x percentage done. Any idea why this is happening?

I made another post about the compatibility with the pi 4, tft to the stock mother board. A lot of people ended up recommending the skr e3 v3, however. I was scrolling on Amazon and came across another mother board branded by creality. Is this one compatible with the pi 4, and tft, if so which one is better.

Ender 3 v2 Neo

Hey, I was looking at getting a raspberry pi with a screen. 1st question, does the raspberry pi 4 work with the ender 3 v2 Neo. And if so will this screen be compatible with the raspberry pi 4.

I was trying to print some key caps and overall the first one turned out great, so I tried making more one by one. Ever time I made a new one I can’t get the top nearly as nice as the first one

Sorry for bad image quality

I have a ender 3 v2 Neo, and was wondering what I can upgrade. I currently have a Spider Hotend, Textured Bed, Capricorn tubing, multiple nozzles. And on my list I have silicone bed mounts, dual z-axis lead screw, linear rail, filament run out sensor, 5015 fans, dual gear extruder with stepper, camera, raspberry pi. Is there anything else I could possibly upgrade?

I just recently installed a spider v3 hotend on my ender 3 v2 Neo. I haven’t done any calibration tests specifically on the spider hotend (besides z offset) and I was wondering what I can do to make it look better. I have done the e-steps not to long ago.

Sorry for bad image quality, just using an iPhone camera.